Manual Euro-MERiDIAN
Chapter 12 Page 12 - 3
Full programming of keypad
addressing, etc. is performed as
follows:
From initial power up:
ADDRESS
[- -]
If already initialised:
Press
D
for 10 seconds
ENTER CODE
[ ]
Enter code
2000
ADDRESS
[- -]
In either case, use
B
or
D
keys
or number keys to insert
address required, eg
01
for
address No. 01
Press YES
LANGUAGE
English [00]
Use
B
or
D
keys to select
language required.
NOTE: This selects the
character set used by the
display. It does NOT provide
language selection for the
main system.
Press YES
ZONE STATUS
1: >25K 2: >25K
This displays the circuit
resistance of the two zones
wired to the keypad. In this
example, both are open circuit.
Press YES
KEYCLICK VOLUME
™ ™ ™ ™ ™ ™ ™[7]
Use
B
or
D
keys to adjust to
volume level required (0
–
7) for
keyclicks at this Keypad
Press YES
Repeat for "TAG VOLUME" and
"MASTER VOLUME"
Press YES
TAG ID
Present Tag
If a Tag is presented, display
shows the tag internal
identification code
Press YES
FACTORY RESET
[ ]
Permits Keypad to be returned
to factory settings
(ie
unaddressed
)
. Enter code
2000
and YES.
Press
A
BACKLIGHT FORCE
[ 0]
Use
B
or
D
keys to adjust to
select “On [1]” to have backlight
always on (except mains fail) or
“Off [0]” for normal operation
Press YES
Euro-MERiDIAN
Time 12:15
Keypad waits for system to be
programmed.
Press A at any time to escape
to normal mode.
Hello, im noob :)