CASTLE EURO Spécifications télécharger pdf (Page 35)

Castle Care-Tech Ltd. Engineering

Page 5 - 8 Chapter 5

Additionally, codes / tags may be

restricted to specific area(s), and

to set only or unset only.

Tags may also be programmed

for Access Control and Ward

Control applications.

Mixing codes of different lengths

is NOT recommended.

From Software 3·1, an option is

available to restrict managers to

programming TAGs only – not

codes. (see page 13-36)

L: VALID CODE SILENCES

ALARM

If the Site Option “Code Stops

Sound” is selected as ‘YES,’

then entering ANY code valid

on the system, at a Setting

Point at which it is valid, will

silence an alarm, regardless of

which area the alarm

originated in.

If the code is not valid for the

area in which the alarm was

generated, the system will

silence, and a ‘misoperation’

signal will be generated (if

programmed). The area in

question will remain ‘set.’

If the option is NOT set, such a

code will silence the alarm

only, if used at a keypad valid

for the area in which the alarm

has occurred, and at which it is

itself valid. It will NOT trigger

the ‘misoperation’ output.

M: DEVICE FAILURE

In the event of a keypad

becoming severed from the

rest of the system, a ‘Device

Alarm’ will be triggered,

identifying the device causing

the alarm, and will apply to ALL

areas that the keypad can set.

If any of these areas cannot be

unset from a remaining

keypad, they will remain set,

and it will NOT be possible to

access the Engineer or Manager

menus, until the fault has been

repaired.

The device will be identified by

a 3-digit code:

The first digit identifies the

device type:

1 = End Station

2 = Keypad

3 = Tag Reader

4 = Zone Expansion Module

5 = Output Module

The remaining digit(s) identify

the individual address of the

type, thus

Device 204 = Keypad

addressed as 04, etc.

N: OTHER FAULT

INDICATIONS

See Appendix A for full details

of other fault messages, and

suggested responses.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 197 198

Commentaires sur ces manuels

Chrisaroks 29 Apr 2024 | 02:45:00

Hello, im noob :)